Atmel Microcontrollers: Difference between revisions
Jump to navigation
Jump to search
Adamcolton (talk | contribs) Created page with "I want to start microcontrollers with the Atmel family because there's a lot of documentation. I can use one of my arduinos as a programmer, but I'd kind of like to use the C..." |
Adamcolton (talk | contribs) |
||
| (3 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
I want to start microcontrollers with the Atmel family because there's a lot of documentation. | I want to start microcontrollers with the Atmel family because there's a lot of documentation. | ||
I can use one of my arduinos as a programmer, but I'd kind of like to use the CH340G I bought. | I can use one of my arduinos as a programmer, but I'd kind of like to use the CH340G I bought. I'd like to be able to program in C, not the Arduino language. | ||
== CH340G == | |||
* 5v | |||
* VCC | |||
* 3v3 | |||
* TXD | |||
* RXD | |||
* GND | |||
VCC is tied to 3v3, so I'm assuming that it provides 5V and 3.3V and it's using the 3.3V to power itself. | |||
== Arduino as ISP == | |||
* http://hardwarefun.com/tutorials/use-arduino-as-an-isp-programmer-to-program-non-arduino-avr-microcontrollers | |||
* https://sdrmvrm.wordpress.com/2012/05/06/flashing-attiny85-via-arduino-isp-using-avrdude/ | |||
* http://elecrab.com/archives/800 | |||
== Videos == | |||
* https://www.youtube.com/watch?v=9ADxPRjZI4Q | |||
* https://www.youtube.com/watch?v=ncobWc61wL4 | |||
* https://www.youtube.com/watch?v=ERY7d7W-6nA | |||
== Notes == | |||
;ICSP | |||
:in-circuit-serial-programmer | |||
:Will have usb in and a 6 pin programmer out | |||
[[Category:Electronics]] | [[Category:Electronics]] | ||
Latest revision as of 22:09, 22 April 2016
I want to start microcontrollers with the Atmel family because there's a lot of documentation.
I can use one of my arduinos as a programmer, but I'd kind of like to use the CH340G I bought. I'd like to be able to program in C, not the Arduino language.
CH340G
- 5v
- VCC
- 3v3
- TXD
- RXD
- GND
VCC is tied to 3v3, so I'm assuming that it provides 5V and 3.3V and it's using the 3.3V to power itself.
Arduino as ISP
- http://hardwarefun.com/tutorials/use-arduino-as-an-isp-programmer-to-program-non-arduino-avr-microcontrollers
- https://sdrmvrm.wordpress.com/2012/05/06/flashing-attiny85-via-arduino-isp-using-avrdude/
- http://elecrab.com/archives/800
Videos
- https://www.youtube.com/watch?v=9ADxPRjZI4Q
- https://www.youtube.com/watch?v=ncobWc61wL4
- https://www.youtube.com/watch?v=ERY7d7W-6nA
Notes
- ICSP
- in-circuit-serial-programmer
- Will have usb in and a 6 pin programmer out