AVR: Difference between revisions
Jump to navigation
Jump to search
Adamcolton (talk | contribs) |
Adamcolton (talk | contribs) |
||
| Line 13: | Line 13: | ||
I need to understand the USB to serial adapters better. For some projects, I will want HID, not for the device to register as a Serial port. | I need to understand the USB to serial adapters better. For some projects, I will want HID, not for the device to register as a Serial port. | ||
http://hackaday.com/2012/02/09/learning-to-use-the-v-usb-avr-usb-firmware-library/ | |||
== SD == | == SD == | ||
To make lots of data available to the chip. | To make lots of data available to the chip. | ||
Revision as of 05:00, 19 November 2015
I want to get good at using these, they're very cheap and well supported.
- Use Arduino bootloader off board
- Use Arduino board to load raw C
USB
This is confusing.
- V-USB
- USBasp
AVR is only fast enough for low-speed USB.
I need to understand the USB to serial adapters better. For some projects, I will want HID, not for the device to register as a Serial port.
http://hackaday.com/2012/02/09/learning-to-use-the-v-usb-avr-usb-firmware-library/
SD
To make lots of data available to the chip.