Magnetics: Difference between revisions
Jump to navigation
Jump to search
Adamcolton (talk | contribs) No edit summary |
Adamcolton (talk | contribs) No edit summary |
||
| Line 18: | Line 18: | ||
Higher tesla is associated with higher core losses, but also higher saturation. | Higher tesla is associated with higher core losses, but also higher saturation. | ||
== DIY Tests == | |||
* epoxy and magnetite | |||
* laminated steel plates | |||
[[Category:Electronics]] | [[Category:Electronics]] | ||
[[Category:Notes]] | [[Category:Notes]] | ||
Revision as of 16:53, 30 July 2018
Magnetics covers transformers and inductors
- https://coefs.uncc.edu/mnoras/files/2013/03/Transformer-and-Inductor-Design-Handbook_Chapter_2.pdf
- https://www.youtube.com/watch?v=xA8HalLJ92c
- https://training.ti.com/understanding-basics-flyback-converter
Transformer
These are just a pain to understand
Larger transformers increase hysteresis loss.
The correct frequency is critical. Ideally, the frequency should be as low as possible without saturating the transformer. Higher frequency increases hysteresis loss.
Materials
- Laminated Iron Alloyws: 1.5-2.0T 50Hz-1KHz
- Powdered Iron: 0.6-0.8T 1KHz - 100KHz
- Ferrites: 0.25-0.5T 20KHz - 20MHz
Higher tesla is associated with higher core losses, but also higher saturation.
DIY Tests
- epoxy and magnetite
- laminated steel plates