H-Bridge: Difference between revisions
Jump to navigation
Jump to search
Adamcolton (talk | contribs) No edit summary |
Adamcolton (talk | contribs) No edit summary |
||
| Line 4: | Line 4: | ||
http://www.modularcircuits.com/blog/articles/h-bridge-secrets/ | http://www.modularcircuits.com/blog/articles/h-bridge-secrets/ | ||
== Discrete Driver == | |||
The bridge itself is pretty simple, but driving it is awful. | |||
Low side is fairly easy. At low voltages, a BJT can be used. At higher voltages, we need to raise the gate voltage because it should only be 10-20v lower than the high side. | |||
The high side driver is a pain because high side N-Chan driving is always a pain. As long as it will never go high for long periods, a bootstrap cap can be used. | |||
[[Category:Electronics]] | [[Category:Electronics]] | ||
Revision as of 15:11, 9 October 2018
These end up getting tricky to build discretely, but high power versions get costly.
I think DRV8701 allows you to mount your own mosfets, which may allow me to increase the power capacity. look for "Full-Bridge Gate Driver" or "full-bridge pre-driver"
http://www.modularcircuits.com/blog/articles/h-bridge-secrets/
Discrete Driver
The bridge itself is pretty simple, but driving it is awful.
Low side is fairly easy. At low voltages, a BJT can be used. At higher voltages, we need to raise the gate voltage because it should only be 10-20v lower than the high side.
The high side driver is a pain because high side N-Chan driving is always a pain. As long as it will never go high for long periods, a bootstrap cap can be used.