Audio System: Difference between revisions
Adamcolton (talk | contribs) No edit summary |
Adamcolton (talk | contribs) No edit summary |
||
| Line 19: | Line 19: | ||
I'd like to do it as one sheet with the speakers spaced meaningfully across. But it may make more sense to do it as either 2 or 4 pieces. | I'd like to do it as one sheet with the speakers spaced meaningfully across. But it may make more sense to do it as either 2 or 4 pieces. | ||
It looks like the speaker will be made of thin spruce, Maple could also work. I'm not quite sure how to do that, but my gut reaction is to make my own 2ply sheet. Cut thin strips of ply and glue them up so that one layer runs perpendicular to the other. | It looks like the speaker will be made of thin spruce, Maple could also work. I'm not quite sure how to do that, but my gut reaction is to make my own 2ply sheet. Cut thin strips of ply and glue them up so that one layer runs perpendicular to the other. I think I'm shooting for less than 1/8th inch, so I'd probably cut the veneer to just under that and sand it down after the glue up. | ||
Revision as of 20:27, 7 August 2018
This would be a fun build
- Bluetooth receiver module:
- 2 x Audio Amplifier Module
- 2 or 4 x Audio Exciter : https://www.parts-express.com/dayton-audio-daex25fhe-4-framed-high-efficiency-25mm-exciter-24w-4-ohm--295-224
Put the electronics in a box, the speakers are based on this so 2 or 4 speaker panels.
Separate Receiver
- https://www.youtube.com/watch?v=9Apn7_QybNo
- Needs separate amps
Integrated
Has 2 50W channels. Probably plenty and simplifies the project.
Structure
Regardless of the other details this is going to have a base and the speakers. The base will mount the electronics but it also provides support for the speakers which are suspended.
I'd like to do it as one sheet with the speakers spaced meaningfully across. But it may make more sense to do it as either 2 or 4 pieces.
It looks like the speaker will be made of thin spruce, Maple could also work. I'm not quite sure how to do that, but my gut reaction is to make my own 2ply sheet. Cut thin strips of ply and glue them up so that one layer runs perpendicular to the other. I think I'm shooting for less than 1/8th inch, so I'd probably cut the veneer to just under that and sand it down after the glue up.