Weights
I want to do this but I couldn't find a cost effective way to start. So I'm going to try making concrete weights.
Weights
- Bar - $35
- Chicken Wire - $6.25
- Quikrete - $3.80 x2
- Nylon Rope - $4
- Clamps - $1 x4
- Paint $3.75
Total: $61
Plan
The bar is galvanized steel, which I will fill with concrete. The bar will be cut to 7ft. The bar should have a strong tensile strength while the concrete has a strong compression strength. I'll put two clamps (plus probably duct tape) as weight stops. The other two clamps will be used to hold the weights on.
Cast weights in 1, 2, 4, 8, 16, 32 lb plates. To cast a weight, measure out the correct amount of dry concrete. Make a mold from cardboard and plastic. Build an insert from chicken wire that is about the size of the mold. Wrap the outside in nylon rope, and add nylon rope spokes. Put the insert in the mold and cover with wet concrete. Let set for a few days. When the weight is ready, remove from the mold and paint it.
Power Rack
Total: $44.05
Basically, this. The big change I'm going to make is that the two sides will only be loosely held together. That way if I need to take it apart, the two sides can be moved separately. I have the wood I need to build the rest of the supports and a basic bench. I also have a bunch of paint left over.
Grand Total
$105
Build Log
Actual cost: $107
Quikcrete
Quikcrete: 3/4C = 323g 1lb = 435.5g 1C = 14.44 in^3 431.7 g/c 29.9 g/in^3 14.57 in^3 / lb
Plastic pipe
408g 1 5/8 in outer diameter 24 5/8 long 16.6 g/in
I'm going to start by casting a 1lb weight. It will take a while to set, but if it doesn't turn out, I can throw it out without worrying. And it will give me some information about working with the concrete.
The math for a plate is
v = h*π*(o^2-i^2) o = ( (v/h*π) + i^2)^0.5
For 1lb plate
v = 14.57 in^3 h = 1 in (chosen arbitrarily) i = 0.8125 in Which gives o = 2.3 in r = 14.45 in